Engaging selector lever position D, N,
R, or P
With the vehicle stationary, depress the
brake pedal before shifting out of selector
lever position P or N; otherwise, the shift
block will not be deactivated and the shift
command will not be executed.
A selector lever lock prevents the following
faulty operation:
– Unintentional shifting into selector
lever position P or R.
– Unintentional shifting from selector
lever position P into another selector
lever position.
1. To release the selector lever lock: with
the brake pedal depressed, press the
button on the front of the selector lever.
2. Move the selector lever into the desired
position.
Engaging selector lever positions:
with a tap-operated selector lever
General information
To prevent the vehicle from creeping after
you select a drive mode, maintain pressure
on the brake pedal until you are ready to
start.
Functional requirements
Only when the brake pedal is depressed is it
possible to change from selector lever posi-
tion P to another selector lever position.
Depending on the transmission version, the
engine may have to be running too.
The selection lever position P cannot be
changed until all technical requirements are
met.
Engaging selector lever position D, N,
R
A selector lever lock prevents the following
faulty operation:
– Unintentional shifting into selector
lever position R.
– Unintentional shifting from selector
lever position P into another selector
lever position.
1. Press and hold the button to release the
selector lever lock.
2. With the driver's safety belt fastened,
briefly push the selector lever in the de-
sired direction, past a resistance point,
Seite 116
CONTROLS Driving
116
Online Edition for Part no. 01405A1E4E3 - II/20
To Next Page
Loading...
Need help?
General
