Mini HARDTOP 2 DOOR User Manual

Overview
Switching the Head-up Display
on/off
When switching on, the projection lens of
the Head-up Display is extended. When
switching off, the projection lens of the
Head-up Display is retracted again.
Via the Central Information Display (CID):
1. "My MINI"
2. "System settings"
3. "Displays"
4. "Head-Up Display"
5. "Head-Up Display"
Display
Overview
The following information is displayed on
the Head-up Display:
– Vehicle speed.
– Navigation instructions.
– Check Control messages.
– Selection list from the instrument clus-
ter.
– Driver assistance systems.
Some of this information is only displayed
briefly as needed.
Selecting displays in the Head-up
Display
Via the Central Information Display (CID):
1. "My MINI"
2. "System settings"
3. "Displays"
4. "Head-Up Display"
5. "Displayed information"
6. Select the desired displays in the Head-
up Display.
Settings are stored for the driver profile
currently used.
Setting the brightness
The brightness is automatically adjusted to
the ambient brightness.
The basic setting can be adjusted manually.
Via the Central Information Display (CID):
1. "My MINI"
2. "System settings"
3. "Displays"
4. "Head-Up Display"
5. "Brightness"
6. Turn the Controller until the desired
brightness is set.
7. Press the Controller.
When the low beams are switched on, the
brightness of the Head-up Display can be
additionally influenced using the instru-
ment lighting, refer to page 148.
The setting is stored for the driver profile
currently used.
Adjusting the height
Via the Central Information Display (CID):
1. "My MINI"
2. "System settings"
Seite 141
Displays CONTROLS
141
Online Edition for Part no. 01405A1E4E3 - II/20

Mini HARDTOP 2 DOOR Specifications

General

Brand	Mini
Model	HARDTOP 2 DOOR
Category	Automobile
Language	English