World map with magnetic zones
Procedure
1. Press and hold the control button for ap-
prox. 3 to 4 seconds. The number of the
set compass zone appears in the mirror.
2. To change the zone setting, press the
control button quickly and repeatedly
until the number of the compass zone
that corresponds with your location ap-
pears in the mirror.
The set zone is stored automatically. The
compass is ready for use again after approx-
imately 10 seconds.
Calibrating the digital compass
The digital compass must be calibrated in
the event of the following:
– The wrong compass point is displayed.
– The point of the compass displayed does
not change despite changing the direc-
tion of travel.
– Not all points of the compass are dis-
played.
Procedure
1. Make sure that there are no large metal-
lic objects or overhead power lines near
the vehicle and that there is sufficient
room to drive around in a circle.
2. Set the currently applicable compass
zone.
3. Press and hold the control button for ap-
prox. 6 to 7 seconds so that "C" appears
on the display. Next, drive in a complete
circle at least once at a speed of no more
than 4 mph/7 km/h. If calibration is suc-
cessful, the "C" is replaced by the points
of the compass.
Left/right-hand steering
The digital compass is already set for right
or left-hand steering at the factory.
Setting the language
Press and hold the control button for ap-
prox. 12 to 13 seconds. Briefly press the
Seite 212
CONTROLS Interior equipment
212
Online Edition for Part no. 01405A1E4E3 - II/20
To Next Page
Loading...
Need help?
General
