Hydroplaning
On wet or slushy roads, a wedge of water
can form between the tires and road sur-
face.
This phenomenon is referred to as hydro-
planing. It is characterized by a partial or
complete loss of contact between the tires
and the road surface, ultimately undermin-
ing your ability to steer and brake the vehi-
cle.
Driving through water
General information
When driving through water, follow the fol-
lowing:
– Deactivate Auto Start/Stop function.
– Drive through calm water only.
– Drive through water only if it is not
deeper than maximum 9.8 inches/25 cm.
– Drive through water no faster than
walking speed, up to 3 mph/5 km/h.
Safety information
NOTICE
When driving too quickly through too
deep water, water can enter into the en-
gine compartment, the electrical system or
the transmission. There is a risk of damage
to property. When driving through water,
do not exceed the maximum indicated wa-
ter level and the maximum speed for driv-
ing through water.
Braking safely
General information
The vehicle is equipped with an Antilock
Braking System ABS as a standard feature.
Perform an emergency stop in situations
that require such.
Steering is still responsive. You can still
avoid any obstacles with a minimum of
steering effort.
Pulsation of the brake pedal and sounds
from the hydraulic circuits indicate that
ABS is in its active mode.
John Cooper Works GP: brake system
The vehicle has a brake system that was
adapted for the increased driving dynamics
of the vehicle.
Because of the design for high braking
power, durability, and controllability, oper-
ating noises may be heard when braking.
However, this noise development has no ef-
fect on the performance, operational safety,
and durability of the brake.
Objects in the area around the pedals
Warning
Objects in the driver's floor area can limit
the pedal distance or block a depressed
pedal. There is a risk of accident. Stow ob-
jects in the vehicle such that they are se-
cured and cannot enter into the driver's
floor area. Use floor mats that are suitable
for the vehicle and can be safely attached
to the floor. Do not use loose floor mats
and do not layer several floor mats. Make
sure that there is sufficient clearance for
the pedals. Ensure that the floor mats are
securely fastened again after they were re-
moved, for instance for cleaning.
Driving in wet conditions
When roads are wet, salted, or in heavy
rain, gently press the brake pedal every few
miles.
Seite 232
DRIVING TIPS Things to remember when driving
232
Online Edition for Part no. 01405A1E4E3 - II/20
To Next Page
Loading...
Need help?
General
