– If the vehicle has not moved again for at
least 2 hours after a trip.
1. Determine the intended tire inflation
pressure levels for the mounted tires.
2. Check the tire inflation pressure in all
four tires, using a pressure gage, for ex-
ample.
3. Correct the tire inflation pressure if the
actual tire inflation pressure deviates
from the intended tire inflation pres-
sure.
4. Check whether all valve caps are
screwed onto the tire valves.
After correcting the tire inflation
pressure
For run-flat tires: reinitialize run-flat tires.
For the Tire Pressure Monitor TPM: reset
the Tire Pressure Monitor TPM.
Checking the tire inflation pressure of
the emergency wheel
Located behind the bumper on the under-
side of the vehicle is an opening for check-
ing the tire inflation pressure.
Tire pressures up to 100 mph/
160 km/h
For speeds of up to 100 mph/160 km/h and
for optimum driving comfort, note the pres-
sure values in the tire inflation pressure ta-
ble, refer to page 250, and adjust as neces-
sary.
These pressure values can also be found on
the tire inflation pressure label on the driv-
er's door pillar.
Do not exceed a speed of 100 mph/
160 km/h.
Seite 249
Wheels and tires MOBILITY
249
Online Edition for Part no. 01405A1E4E3 - II/20
To Next Page
Loading...
