Jacking up the vehicle
Warning
Hands and fingers can be jammed when
using the vehicle jack. There is a risk of
injury. Comply with the described hand
position and do not change this position
while using the vehicle jack.
1. Hold the vehicle jack with one hand, ar-
row 1, and grasp the vehicle jack crank
or lever with your other hand, arrow 2.
2. Insert the vehicle jack into the rectan-
gular recess of the jacking point closest
to the wheel to be changed.
3. Extend the vehicle jack by turning the
vehicle jack crank or lever clockwise.
4. Take your hand away from the vehicle
jack as soon as the vehicle jack is under
load and continue turning the vehicle
jack crank or lever with one hand.
5. Make sure that the vehicle jack foot
stands vertically and at a right angle be-
neath the jacking point.
6. Make sure that the vehicle jack foot
stands vertically and perpendicularly be-
neath the jacking point after extending
the vehicle jack.
7. Crank the vehicle up, until the vehicle
jack is with the entire surface on the
Seite 269
Wheels and tires MOBILITY
269
Online Edition for Part no. 01405A1E4E3 - II/20
To Next Page
Loading...
Need help?
General
