4
2. Connect Red Clamp to the positive (+) battery terminal, Black
Clamp to the negative (-) battery terminal. Cable will test the
voltage and SOH(State of Health) of the battery, show the data on
the display.
3. Operate according to the instruction of the LCD Display:
3.1. When LCD display shows JUMP START READY, indicating
connection is correct and the circuit is working, crank the engine
directly.
3.2. When LCD display shows CLAMPS REVERSED, ALARM RINGS,
indicating the connection is wrong, correct the clamps before
LCD display shows JUMP START READY, then crank the engine
within 30s.
Beep ,Beep
To Next Page
Loading...