30
PROBLEM CHECKLIST SOLUTION
The measurement
is not accurate or
there is some doubt
about its result
The measurement has been
taken incorrectly
Make sure you
have followed the
instructions for use
correctly
The temperature of the
patient and the infrared
sensor have not been
stabilised
Keep the thermometer
and the patient in
the room where the
measurement is to be
performed for at least
30 minutes before
using it
The measurement has been
taken outdoors
Take the measurement
inside a room
The thermometer has been
kept too long in the hand
Place the thermometer
on a surface in the
room where the
measurement is to
be taken and allow it
to cool
Other malfunctions Contact the MINILAND technical service.
6. CARE AND CLEANING
· To ensure the accuracy of the measurements, the distance (D) and infrared
(E) sensors must be clean and free of marks. Fingerprints or other dirt may
affect the accuracy of the measurements.
· Clean both sensors with a cotton swab slightly moistened with alcohol
and dry them immediately with a cotton swab. To clean the thermometer
casing, use a soft dry cloth.
· Never clean the thermometer with abrasive cleaning products, solvents
or benzene or immerse it in water or other liquids.
· After cleaning, store it in a clean and dry place at room temperature. Never
expose it to extreme temperatures and humidity or direct sunlight.
6.1. CALIBRATION
The thermometer is calibrated during its manufacturing process. If the
thermometer is used following the instructions provided in the manual,
periodic re-calibration is not necessary. If at any time you have doubts about
ENGLISH
To Next Page
Loading...
