MinimumRC Butterfly V1 - Butterfly V1 Flight Test Setup; V-Tail Mixing Mode Configuration; Control Stick Neutrality Verification; Center of Gravity (CG) Adjustment

First test flight
1
Set the transmitter to V-tail mixing mode:
·Push/pull the elevator control stick, and the tails on both sides tilt up/down at the
same time.
·Push/pull the rudder control stick, and the tails on both sides tilt left/right at the
same time.
2
When the control stick is at the central point, the tails on both sides are parallel to
the tail of the fuselage
3
Adjust the center of gravity to the 30%-50% position of the leading edge of the
wing.
4
The full-motion tail is exceptionally sensitive and it is recommended to reduce the
channel travel to 80%.
Enjoy your flight!