MINIWARE TS80P - Page 9

& Operation
4.1 Installation
> 4
ae mana) (DE EED
1) Insert soldering tip into the soldering controller;
2) Connect TS80P and power source with a USB Type-C cable, turn on the power and follow the
instruction.
Kâ Note: If“Sen-Err” appears on TS8OP after power is on, it means the soldering tip is not installed
securely, please install again.
4,2 Default Settings
Default temperature unit C
Default temperature 300°C
Sleep mode temperature 200°C
Adjustable temperature range 100°C-400°C (Max)