Need help?Do you have a question about the minkaAire Great Room Traditional F539-HBZ and is the answer not in the manual?
Ensure power is off at the breaker before installation and read all safety information and diagrams.
Ensure electrical connections meet codes, hire an electrician if needed, and verify blade clearance.
Note ceiling weight limits, use provided screws for direct joist mounting, and secure all components.
Avoid inserting objects into fan blades and turn off the fan for cleaning or maintenance.
Illustrates different methods for mounting the outlet box to the ceiling structure.
Remove outlet box knock-outs and securely attach the hanger bracket plate to the building joist.
Attach hanger bracket, loosen set screws, remove hanger ball, feed wires through downrod, and secure it.
Lift motor assembly and seat the downrod ball into the hanger bracket's registration slot.
Insert the receiver into the hanger bracket with the flat side facing upwards towards the ceiling.
Connect fan motor wires (WHITE, BLACK, BLUE) to the corresponding receiver terminals.
Connect the house supply wires (WHITE, BLACK) to the receiver's AC IN terminals.
Connect ground wires from the outlet box to the hanger ball and bracket ground wires.
Remove the old wall plate and switch from the existing electrical outlet box.
Make electrical connections for the transmitter, including the ground wire to the outlet box screw.
Tuck all wire connections neatly into the outlet box and secure the transmitter and wall plate.
Loosen specific screws on the hanger bracket to allow the canopy to slide and be positioned.
Slide the canopy up, align keyholes, lock it, and tighten set screws for a snug fit.
Securely attach each fan blade to its respective blade bracket using the provided screws.
Remove motor stops, align blade brackets with motor holes, and secure with screws and washers.
Connect the switch cup and fan wire molex connectors, then secure the switch cup to its plate.
Use specific buttons to set fan speeds (Low, Medium, High) and to turn the fan off.
Utilize buttons to turn the light on/off and adjust its brightness level.
Change blade rotation direction for seasonal airflow and control overall fan/light power.
Periodically check component security and clean the fan with a soft, dry cloth.
Use soft cloths for the finish, apply polish, and clean glass with mild soapy water.
Motor bearings are permanently lubricated; ensure power is OFF before any repairs.
Troubleshoot fan not starting, lights shutting off, or wattage limiting device issues.
Address unexpected fan operation from interference or fan wobble by checking screws and using kits.
Follow steps to change frequency settings to resolve radio interference affecting operation.
To Next Page
General