TEMP 65 °F DPTH 5 ftHDG 255°
TEMP 72 °F DPTH 1 ftBRG 359°
TEMP 65 °F DPTH 5 ftHDG 255°
TEMP 72 °F DPTH 1 ftBRG 359°
minnkotamotors.com
©2016 Johnson Outdoors Marine Electronics, Inc.
Screen
Navigation
Ok
Speed Up
Speed
Down
Dashboard
Info Boxes
Prop
On/Off
Steer Left
Steer Right
Spot-Lock
Home
Header
Display
Screen
Content
Area
i-PILOT
®
LINK
™
QUICK REFERENCE GUIDE
REMOTE
COMPATIBLE WITH ALL BLUETOOTH
®
ENABLED i-PILOT® LINK
TM
SYSTEMS
Home - Press to bring up the Home
Screen Buttons.
Screen Navigation - Press to
navigate the menu without touching
the screen. Press and hold to lock
and unlock the remote.
Ok - Press to accept menu selections.
Press to power remote on. Press
and hold for 3 seconds to power
remote off .
Speed Up & Speed Down -
Press to increase or decrease motor
speed.
Steer Left & Steer Right -
Press to steer the motor to the left
or to the right.
Prop On/Off - Press to turn the
Prop on and off .
Spot-Lock - Press to enable and
disable Spot-Lock.
Control Buttons
Dashboard
GPS Signal
Strength
Motor
Battery
Time
Remote
Battery
Humminbird
Connection
Humminbird Connection
Displays white arrows to show
when the i-Pilot Link controller
is communicating with the
Humminbird. Grey arrows indicate
that there is no communication.
Motor Battery t n - Displays
motor battery level when prop is
disengaged.
Time - Displays the current time.
Remote Battery - Displays the
battery level of the remote.
GPS Signal Strength -
Displays the level of GPS signal
strength. If no bars appear, or if the
bars are fl ashing, the system has
not yet acquired a GPS fi x.
Speed Over Ground - Displays
the current speed over ground.
High Speed Bypass - Displays
when High Speed Bypass is engaged.
Prop On/Off - Displays when
the Prop is enabled. Rotates when
the Prop is on and the Prop Speed
is greater than zero. Blinks when
a mode of navigation is used that
requires the prop to be enabled.
Cruise Control - Displays when
Cruise Control is engaged along
with the Target Speed.
Prop Speed - Displays the current
Prop Speed. Can be adjusted in 1/2
speed increments between 0 and 10.
Speed
Over Ground
Prop
On/Off
Cruise
Control
Prop
Speed
High Speed
Bypass
Header
Legacy AutoPilot - The
AutoPilot button is used to engage
and disengage Legacy AutoPilot.
Advanced AutoPilot - The
AutoPilot button is used to engage
and disengage Advanced AutoPilot.
Record - The Record button is used
to start and stop recording an iTrack.
HSB - Select the HSB (High Speed
Bypass) button to engage High
Speed Bypass. High Speed Bypass
automatically sets the Prop speed
to 10. Double press to engage.
Single press to disengage.
Lock Keys - Select the Lock
button to lock the buttons and
touch screen. Pressing and holding
the Screen Navigation
button
also locks and unlocks the remote.
Cruise Control - Press the Cruise
Control button to enable or disable
Cruise Control. Once Cruise Control
is enabled, pressing the Speed Up
or Speed Down buttons
will change the Target Speed rather
than the Prop Speed.
Mark Waypoint - Press to mark
a Waypoint.
Settings - Press the Settings
button to open the Settings menu
and adjust settings within the i-Pilot
Link system.
Options - Press the Options button
to open the Options menu and
adjust options within the i-Pilot Link
system.
Go To Spot-Lock - The Go
To Spot-Lock button is used to
open a menu used to navigate to a
Spot-Lock location. The i-Pilot Link
system will only bring up Spot-
Locks within a quarter mile range.
Go To iTrack - The Go To iTrack
button is used to open a menu
used to navigate to an iTrack. The
i-Pilot Link system will only bring up
iTracks within a quarter mile range.
Go To Waypoint - The Go To
Waypoint button is used to open
a menu used to navigate to a
Waypoint location. The i-Pilot Link
system will only bring up Waypoints
within a quarter mile range.
Ulterra t - The Ulterra button is
used to access functions specifi c to
controlling the Ulterra.
Home Screen Buttons
Bearing - Bearing is the direction
from the boat's current location
to the target destination during
navigation.
Heading - Heading is the direction
that the motor is pointing.
Temperature - The current
water temperature based
on
communication with the Humminbird.
Depth - The current water depth
based on communication with the
Humminbird.
Depth
Bearing
Temperature
Heading
TEMP 65 °F DPTH 5 ftHDG 255°
TEMP 72 °F DPTH 1 ftBRG 359°
TEMP 65 °F DPTH 5 ftHDG 255°
TEMP 72 °F DPTH 1 ftBRG 359°
TEMP 65 °F DPTH 5 ftHDG 255°
TEMP 72 °F DPTH 1 ftBRG 359°
TEMP 65 °F DPTH 5 ftHDG 255°
TEMP 72 °F DPTH 1 ftBRG 359°
Info Boxes
t Only available with Ulterra. n Only available with Ultrex.
NOTE: The information displayed in the
Content Area changes based on menu
selections. It may display Home Screen
Buttons, Active Bands, Control Screens and
other menus.
To Next Page
Need help?
General
