Prop On/Off
Increase
Speed
Decrease
Speed
Steer Right
Steer Left
High Speed
Bypass
AutoPilot
Spot-Lock
Spot-Lock
Press to enable Spot-Lock. When Spot-Lock is enabled
from the Micro Remote, use either the i-Pilot or i-Pilot
Link remote, or the fish finder if you want to save it.
AutoPilot
Press to enable AutoPilot. The selection between
Legacy AutoPilot and Advanced AutoPilot must be
made from either the i-Pilot or i-Pilot Link remote.
Speed Down & Speed Up
Press to decrease or increase motor speed.
Prop On/Off
Pressing this button will turn the Prop on and off.
Steer Left & Steer Right
Press to steer the motor to the left or to the right.
High Speed Bypass
Bypasses the current motor speed to speed 10.
Double press to engage. Single press to disengage.
NOTICE: If your motor is connected to a Heading Sensor,
the Speed Down
(backwards), Speed Up (forward),
Steer Right
and Steer Left buttons function change to
Jog the boat while in Spot-Lock.
NOTICE: When the remote is being paired to the i-Pilot
Controller, the High Speed Bypass
button and the AutoPilot
button need to be held down simultaneously. Make sure to also
hold the Pair
PAIR
button on the Control Head to successfully pair
the remote to the controller.
NOTICE: A remote can be paired to one controller at a time.
A controller can have multiple remotes paired to it.
4. While holding the Pair
PAIR
button on the Control Head, push and
hold the High Speed Bypass
button and AutoPilot button
on the remote simultaneously.
NOTICE: Make sure the remote stays within range of the
Control Head during the pairing process.
An i-Pilot controller may pair up to 5 remotes. These five remotes can
be a combination of standard i-Pilot remotes and Micro Remotes. Any
additional remotes can be paired using the following steps. Once the
maximum number of remotes have been paired, the controller will start
replacing the oldest paired remote in memory with the new remote.
1. Power up the trolling motor.
2. Locate the Pair
PAIR
button at the top of the Control Head.
3. Push and hold the Pair
PAIR
button down. A consistent tone will be
emitted from the Control Head.
5. Once successfully paired, 3 longer beeps will be emitted from the
Control Head and the remote will be paired.
Scan to view the complete Micro Remote
Owner’s Manual online. The Owner's Manual is
available at minnkotamotors.com and includes
informaton on compatibility, safety considerations,
compliance, maintenance, parts and more.
MICRO REMOTE
QUICK REFERENCE GUIDE
Compatible with all Bluetooth
®
enabled i-Pilot
®
Link
TM
and i-Pilot systems only.
REMOTE
PAIRING
minnkotamotors.com©2018 Johnson Outdoors Marine Electronics, Inc.
MANUAL CONTROL BUTTONS
NAVIGATION BUTTONS
Pairing the Micro Remote to your
Controller
To Next Page
Need help?
General
