MKA-16-03 Elec. Steer Quick Release Bracket
1854035
MOUNTING CONSIDERATIONS
TOOLS AND RESOURCES REQUIRED
Complete Typical Installation
Item /
Assembly
Part # Description Qty.
A 2990114 QCK REL PLATE/THUMB SCREW ASM 1
2
✖
PLATE-MNT,TOP PD QUICK RELEASE 1
4
✖
PLATE-MNT,BTM PD/AP QK/RL 1
6 2373421 SCREW-5/16-18 X 3/8 SHCS S/S 1
8 9951778 LOCKWASHER-1/4" ZINC 1
10 2011385 SCREW-TENSION/NEW KNOB 1
p
2374954 INSTR.SHEET MKA-16-03 BULK QRB 1
B 2994932 BAG ASM, ELEC. STEER QRB 1
12 2371728 WASHER-FENDER 1/4 X 1 1/4 ZP 4
14 2373413 SCREW-1/4-20 X 7/8 HHCS ZP 4
16 2263104 NUT-1/4-20 NYLOCK ZP 8
18 2373516 BOLT-1/4-20 X 2" HHC ZP 4
2
6
8
10
4
A
B
14
18
12
16
• #3 Phillips Screw Driver
• Drill
• 9/32” Drill Bit
• 7/16” Box End Wrench
• A second person to help with
the installation
It is recommended that the motor be mounted as close to
the centerline of the boat as possible. The motor must not
encounter any obstructions as it is lowered into the water or
raised into the boat when stowed and deployed. Make sure
the motor rest is positioned far enough beyond the edge of
the boat. Make sure the area under the mounting location is
flat, clear to drill holes and install nuts and washers.
p Not shown on Parts Diagram.
✖ This part is included in an assembly and cannot be ordered individually.
minnkotamotors.com | 1
©2018 Johnson Outdoors Marine Electronics, Inc.
FOR USE WITH ALL MINN KOTA
®
POWERDRIVE™, PONTOON POWERDRIVE™, ULTERRA™ AND TERROVA
®
FRESHWATER TROLLING MOTORS & THE POWERDRIVE™
PONTOON HAND CONTROL BRACKET & DECKHAND 40
NOTE: Images are a graphical representation and
may vary slightly from your motor.
To Next Page
Need help?
General
