121
Data Processor
Functions
Selecting the limit value in P.114 displays the [limit value] selection screen.
[Operating Procedure]
1
Use the key to select a color difference target
color.
2
Press the Measure/Enter key
.
• The tolerance type screen appears.
3
Select the “∆E*” as the tolerance type.
4
Press the Measure/Enter key
.
• The limit value setting screen will appear.
• If ∆E is already set, go to step 6 as the set color difference
tolerance data is displayed.
［ＴＯＬＥＲＡＮＣＥ］ １／１
◎ＴＡＲＧＥＴ
Ｔ０３
Ｔ０２
Ｔ０１
Ｐ００
C
P
［０００１］
［ＴＯＬＥＲＡＮＣＥ］
◎ＴＯＬＥＲＡＮＣＥ ＴＹＰＥ
ＥＬＬＩＰＴＩＣＡＬ
ＢＯＸ
ΔE＊
ＢＯＸ ＆ ΔE＊
Ｐ００ Ｃ P ［０００１］
［ＴＯＬＥＲＡＮＣＥ］
◎ＴＯＬＥＲＡＮＣＥ
Ａ Ｂ
＋ ＋
− −
Ｃ Ｄ
＋ ０．００
−
Ｐ００ Ｃ ［０００１］
P
ΔL＊
Δa＊
Δb＊
ΔE＊
5,7
1,3,5,7
2,4,6,8
∆E
This judges whether or not the value of the measured color difference is within the range of the ∆E set
for the color difference target color.
∆E is displayed as followings depending on set color spaces.
∆E*, ∆E, ∆E94, ∆E99, ∆E00, CMC
Set a color difference target color ahead of time before setting ∆E.
Selection screen
Tolerance type screen
Setting screen
To Next Page
Loading...
