FrameMaker Ver.5.5E(PC) DIS/REASSEMBLY, ADJUSTMENT FOR Di152/Di183
01.09.03
D-54
(2) Loop Length Adjustment (1st and 2nd Trays, Bypass Tray)
Requirement
• Adjust so that a loop of an adequate length is formed in the paper before the Synchroniz-
ing Roller as the paper is being fed through the copier.
NOTE
• This adjustment is made when the amount of leading edge void varies, or when paper
skews, is folded, or is misfed.
<Adjustment Procedure>
1. Enter the Tech. Rep. Choice mode.
2. With “c--” shown on the Display, enter the code number “8” from the 10-Key Pad and
press the Start key to enter the “Loop Length Adjustment (1st Tray)” mode.
3. Press the Clear key to clear the current setting value.
4. Enter the setting value from the 10-Key Pad and press the Start key to validate the
entry.
Adjustment Instructions
• Adjust by changing the setting value until the problems of variations in the amount of
leading edge void, paper skew, folded paper, and paper misfeed are eliminated.
5. Following the same procedure, adjust the loop length for the 2nd Tray and Bypass Tray.
Mode Code No. Setting Range
Tech. Rep. Choice
8 (1st Tray)
0 to 14,
1 step: Approx. 0.5 mm
9 (2nd - 5th Tray)
10 (Bypass Tray)
To Next Page
Loading...
