Minolta Di251 - Page 174

4
Customizing Your Copy
4-72 Di251/Di351
5
Set the width of the file margin with
the arrow keys.
?
What must be considered?
The original will be printed on
the copy offset by the width of
the file margin.
Ü If the file margin has been set
too wide, part of the image on
thecopymaybelost.
6
Confirm your inputs with [ENTER].
The auxiliary functions are shown
again.
Ü If necessary, make additional copier settings. Start the copy cycle by
touching [START].
.
Combining file margin settings!
Settings: file margin left,
file margin width 0 mm
Result:
The 2nd original will be printed in
the same direction as the
1st original.
Settings: file margin above,
file margin width 0 mm
Result:
The 2nd original will be printed in
the opposite direction to the 1st
original.