Minolta Di251 - Copying Originals Using the Automatic Document Feeder

Initial Steps . . .
3
Di251/Di351 3-9
Copying Originals using the Automatic Document Feeder
Feed originals with the automatic document feeder.
1
Set the document guide to the size
of the original.
?
Are you copying originals that
are larger than A4?
Ü Pull out the document feed tray
extender and the original
stopper.
2
Placeupto70originals(80g/m
2
)in
the automatic document feeder.
The side that is to be copied must
be up.
?
Doyouhavetoloadtheoriginals
differently than illustrated here?
Ü Define the original document
alignment. For more
information, see page 4-47.
3
Ensure that the stack of originals
does not exceed the maximum fill
height (see Ä mark on the
document feeder).
4
Push the originals flush up against the feed chamber.
5
Start the copy cycle.
The originals are pulled in starting with the top sheet.
Note the following important information!
Suitable originals for the automatic document feeder are:
Type of originals: • Single sheets of smooth standard paper
• Multiple page feed 52.5 to 81.4 g/m
2
Original size: • 1/2-sided originals A3L to A5
• with Mixed Original Detection A3 L to A5 C
Original Stopper
Extender