I-14Di251/Di351 Rev. 1.1.0.0/03.01
left
5. Place the job tray unit onto the mounting
frame as shown.
NOTE
When placing the job tray unit, be sure to raise
the plastic sensors indicated by the arrows to
prevent them from touching the mounting frame.
6. Remove the dummy connector from the
copier harness and plug in the copier harness
at the rear of the and the copier.
NOTE
Install the job tray unit rear side and front end so
the pins pass through the holes in the parts
indicated by the arrows.
Make sure that the harness is plugged in
correctly and that the harness does not become
caught between the job tray unit and the copier.
7. Use an accessory screw (4 x 8 mm) to secure
the job tray unit at the front.
NOTE
Tighten the screw after aligning the hole position.
To Next Page
Loading...
