I-29 Di251/Di351Rev. 11..0.0/03.01
right
3. Position the Automatic Document Feeder.
NOTE
Push the excess length of the cable to the rear of
the Automatic Document Feeder.
4. Connect the (two) connectors of the
Automatic Document Feeder and install the
ground wire.
Screw 4x8 Silver
5. Insert the tie band fitted to the cable of the
Automatic Document Feeder into the frameof
the copier to secure the cable in position.
6. Secure the ADF.
Screw 4x8 Silver
7. Cut out the knockout shown in the illustration.
8. Reinstall the cover which has been removed.
To Next Page
Loading...
