I-36Di251/Di351 Rev. 1.1.0.0/03.01
left
4. Secure both hinges of the Duplexing Document Feeder with the 2 remaining
Shoulder Screws. Tighten the screws completely with a screwdriver so that they
will not come loose.
NOTE
Tighten the Shoulder Screws until there is no clearance between the hinges and the
copier body.
5. Remove all the tape from the Duplexing
Document Feeder.
Remove the plastic bag from the Hookup
Cord.
6. Install the exit tray.
7. Secure the screw from underneath the unit.
Tapes
To Next Page
Loading...
