Minolta Di251 - Checking and Adjusting the Document Stop Position; In the 1-Side Original Mode

I-38Di251/Di351 Rev. 1.1.0.0/03.01
left
Checking the Skewed Feeding
Check whether the paper on the Original Glass
leans in the “a” direction or “b” direction.
Tolerance :
1.0 mm or less against the Original Width Scale
If distance “a” or “b” Is out of tolerance, carry out
the following procedure.
Adjusting the Skewed Feeding
1. Open the Duplexing Document Feeder and
loosen the 2 shoulder head screws securing
the Right Hinge. Loosen one shoulder head
screw securing the Left Hinge.
2. If the paper on the Original Glass leans like
“a”, shift the right side of the Duplexing
Document Feeder toward the rear side.
If the original leans like “b”, shift the right side
of the Duplexing Document Feeder toward
the front side.
Then tighten the shoulder head screws.
1.8.4 Checking and adjusting the document stop position in the 1-side
original mode
1. Set the copier into the following modes:
Auto Paper Select
One-sided Original - One-sided Copy
2. Place a sheet of A4 or Letter paper crosswise
onto the Document Feed Tray.
3. Press the start key and open the paper guide
F1 as soon as the paper is fed into the unit
and the scanning starts.
b
a