I-39 Di251/Di351Rev. 11..0.0/03.01
right
4. After the paper is fed onto the Original Glass,
open the Duplexing Document Feeder gently.
NOTE
When the Duplexing Document Feeder is
opened quickly, the paper will be knocked out of
position.
Checking the Document Stop Position
Measure the distance the edge of the sheet
deviates in the “c” or “d” direction from the edge
of the Original Scale.
Recommended:
Within 1 mm in the C direction from the edge of
the Original Scale.
If the distance is out of tolerance, carry out the
following procedure.
Adjusting the Document Stop Position
1. Access the initial Tech. Rep. Mode screen.
(Refer to the Service Manual for the
procedure.)
2. Touch “Tech.Rep.Choice”.
3. Touch “ADFR”.
cd
Level History
To Next Page
Loading...
