Minolta Di251 - Checking the Document Stop Position; In the 2-Sided Original Mode

I-41 Di251/Di351Rev. 11..0.0/03.01
right
1.8.5 Checking and adjusting the document stop position in the 2-sided
original mode
1. Set the copier into the following modes:
Auto Paper Select
2-sided Original 1-sided Copy
2. Place one sheet of A4 or Letter size paper,
crosswise onto the Document Feed Tray.
3. PresstheStart keyand openthepaperguide
F1 as soon as the scanning for the 2nd side
of the original starts.
4. After the paper is fed onto the Original Glass,
open the Duplexing Document Feeder gently.
NOTE
When the Duplexing Document Feeder is
opened quickly, the paper will be knocked out of
position.
1.8.6 Checking the Document Stop Position
Measure the distance the edge of the sheet
deviates in the “c” or “d” direction from the edge
of the Original Scale.
Recommended:
Within 1 mm in the C direction from the edge of
the Original Scale.
If the distance is out of tolerance, carry out the
following procedure.
cd