Minolta Di251 - Checking and Adjusting the Document Stop Position in the Single Feed Copy Mode; Checking the Document Stop Position

I-43 Di251/Di351Rev. 11..0.0/03.01
right
1.8.9 Checking and adjusting the document stop position in the single
feed copy mode
1. Set the copier into the following mode:
Auto Paper Select
One-sided Original One-sided Copy
2. Insert a sheet of A4 or Letter size paper
crosswise into the Single Feed Tray along the
Rear Paper Guide.
3. When the paper feeds automatically and the
scanning starts, open the paper guide
F1 immediately.
4. After the paper is fed onto the Original Glass,
open the Duplexing Document Feeder gently.
NOTE
When the Duplexing Document Feeder is
opened quickly, the paper will be knocked out of
position.
1.8.10 Checking the Document Stop Position
Measure the distance the edge of the sheet
deviates in the “c” or “d” direction from the edge
of the Original Scale.
Recommended:
Within 1 mm in the C direction from the edge of
the Original Scale.
If the distance is out of tolerance, carry out the
following procedure.
cd