Minolta Di251 - Adjusting the Position of the Single Feed Copy; Checking the Position of the Single Feed Copy; Securing the Stoppers

I-47 Di251/Di351Rev. 11..0.0/03.01
right
1.8.16 Checking the Position of the Single Feed Copy
Check the paper to see how many mm its rear
edge deviates in the “A” or “B” direction with
reference to a line 4.0 mm to the front of the end
face of the FD Scale.
Allowable deviation : 4.0 ± 1.0 mm
1.8.17 Adjusting the Position of the Single Feed Copy
Move the Guide Plate to the front or back as
necessary to meet the above requirements.
Less than 3.0 mm : To the front
More than 5.0 mm : To the back
1.8.18 Securing the stoppers
Remove the shoulder screws (one each at the
right- and left-hand side) in the rear of the copier
and tighten these shoulder screws into the
corresponding upper holes.
A
B
4±1mm