Minolta Di251 - Installing the Accessories

I-52Di251/Di351 Rev. 1.1.0.0/03.01
left
1.9.2 Installing the Accessories
1. Peel off the seal covering the area where the
stabilizing pin and magnet will be attached.
2. Attach the enclosed stabilizing pin and
magnet with the enclosed flat-head screws to
the left side of the copier as shown.
3. Attach the rail guide to the left side of the
copier as shown in the illustration.
If the large-capacity cabinet, copy table or
copy desk is installed, attach the rail guide at
the same location.
NOTE
Be sure to fit the correct side of the rail guide onto
the copier, and make sure that it snaps into place.
4. Insert one end of the rail into the rail guide on
the copier.
5. Slide the other end of the rail installed in step 3 into the rail guide on the finisher.
NOTE
Insert the rail until it snaps into place.
At this time, the finisher should stay attached to the copier, even if you try to pull it
away.