FrameMaker Ver5.5E(PC) Di251/Di351 SWITCHES ON PWBs/TECH. REP. SETTINGS
05.03.01
S-21
5. IR-Erasure Width
• Make the adjustment of original erase width on the IR side.
Note:
• For details, see DIS/REASSEMBLY, ADJUSTMENT
6. Book Center Erasure
• Adjust the center erase width in Book copying.
Note:
• For details, see DIS/REASSEMBLY, ADJUSTMENT
(2) System Input
• The function allows the Tech. Rep. to define the paper size input, and make settings.
Touch Panel
Display
Setting (The default is ).
IR-Erasure Width Set the forced erasure width along the four edges of the paper.
Touch Panel
Display
Setting (The default is ).
Book Center
Erasure
Adjust the center erase width.
Touch Panel
Display
Setting (The default is ).
Paper Size Input Set the paper size.
<Procedure>
1. Select the paper source.
2. Select the paper size. If a nonstandard size is to be used, enter
the paper size from the 10-Key Pad.
3. Touch “END” to validate the new setting.
Change Fixed
Zoom
Change a fixed zoom ratio to a desired value.
<Procedure>
1. Touch the key of the fixed zoom ratio to be changed.
2. Press the Clear key. Press the Interrupt key to undo the clearing
operation, restoring the original setting.
3. Enter the new ratio from the 10-Key Pad.
4. Touch “Input” to validate the new setting.
Highlighted
0 mm....................................... .......................................3 mm
Smaller Greater
0
Highlighted
2 mm....................................... .....................................20 mm
Smaller Greater
0
Highlighted
To Next Page
Loading...
