FrameMaker Ver5.5E(PC) Di251/Di351 MECHANICAL/ELECTRICAL
.05.03.01
M-9
7-1. I/C Drive Mechanism
• Drive from the I/C Motor is transmitted via a gear train to the PC Drum and Hopper.
7-2. Identification and Life of I/C
• When the Start key is pressed or the Side Cover is opened and closed, the copier deter-
mines whether the I/C is new or one which has been used previously.
• The copier monitors the I/C life by storing in memory the period of time during which the
PC Drum has turned. The data is cleared when a new I/C is installed in the copier.
Electrical Component Control Signal ON OFF Wiring Diagram
M1 PJ5A-3 L H 5-G
4011M021AA
PC Drum Drive Gear
Hopper Drive Gear
I/C Motor M1
To Next Page
Loading...
