FrameMaker Ver.5.5(PC) Di251/Di351 TROUBLESHOOTING
05.03.01
T- 9
✽ If a communications error occurs between MFB2 Board and Master Board during a copy
cycle, it forces a paper misfeed condition ( displayed on the Touch Panel). If that hap-
pens, check the circuit between MFB2 Board and Master Board for proper connection
and, if it is intact, replace the board.
<Resetting the Display>
✽ If the misfeed display is not reset by these procedures, check the misfeed detecting sen-
sor at the paper location.
Misfeed in the copier Misfeed in the option
Open the relevant door, remove all sheets of
paper misfed and left inside, and then open
andclosetheSideCover.
Remove all sheets of paper misfed and left
inside, and then raise and lower or discon-
nect and reconnect the option.
To Next Page
Loading...
