FrameMaker Ver.5.5(PC) Di251/Di351 TROUBLESHOOTING
05.03.01
T- 2 4
Paper Take-Up Misfeed (PF-117) Troubleshooting Procedures
• Misfeed is detected when the cassette is slid in.
Step Check Result Action
1 Paper meets product specifications. NO Change paper.
2 Paper is curled, wavy, or damp. YES Change paper.
Instruct user in correct
paper storage.
3 Paper Take-Up Roll is dirty, deformed, or worn. YES Clean or change.
4 Mylar is dirty or deformed. YES Clean or change.
5 Lift 1/Lift 2 is dirty, deformed, or scratchy. YES Clean or change.
6 Paper Empty Sensor 1 operation check
through I/O check
NO Change Paper Empty Sen-
sor 1.
Change LCC Control
Board.
Change Control Board.
7 LCC Paper Take-Up Sensor operation check
through I/O check
NO Change LCC Paper Take-
Up Sensor.
Change LCC Control
Board.
Change Control Board.
8 Paper Standby Position Sensor operation
check through I/O check
NO Change Paper Standby
Position Sensor.
Change LCC Control
Board.
Change Control Board.
9 Paper transport operation check: paper is
transported up to Paper Standby Position Sen-
sor when the cassette is slid in with paper
loaded only in Lift 2.
YES Change LCC Control
Board.
Change Control Board.
Change Master Board.
10 Paper Take-Up Clutch 1 operation check: the
voltage across CN7A-8 on LCC Control Board
and GND changes from DC24 V to DC0 V
when the cassette is slid in with paper loaded
only in Lift 2.
NO Change LCC Control
Board.
Change Control Board.
Change Master Board.
11 Paper Take-Up Clutch 2 operation check: the
voltage across CN7A-6 on LCC Control Board
and GND changes from DC24 V to DC0 V
when the cassette is slid in with paper loaded
only in Lift 2.
NO Change LCC Control
Board.
Change Control Board.
Change Master Board.
12 Paper transport operation check: a misfeed is
detected when the cassette is slid in with paper
loaded only in Lift 1.
YES Change Paper Take-Up
Clutch 1.
NO Change Paper Take-Up
Clutch 2.
To Next Page
Loading...
