FrameMaker Ver.5.5(PC) Di251/Di351 TROUBLESHOOTING
05.03.01
T- 2 5
• Paperisnottakenupatall.
• Paper is at a stop near the Vertical Transport Roller.
Step Check Result Action
1 Paper meets product specifications. NO Change paper.
2 Paper is curled, wavy, or damp. YES Change paper.
Instruct user in correct
paper storage.
3 Feed Roll and Separator Roll are dirty,
deformed, or worn.
YES Clean or change.
4 Paper take-up guide plate is dirty or deformed. YES Clean or change.
5 Separator Clutch operation check: the voltage
across CN7A-2 on LCC Control Board and
GND changes from DC24 V to DC0 V when the
Start key is pressed.
YES Change Separator Clutch.
NO Change LCC Control
Board.
Change Control Board.
Change Master Board.
Step Check Result Action
1 Vertical Transport Roller/Roll is dirty, deformed,
or worn.
YES Clean or change.
2 Registration Sensor operation check through
I/O check
NO Change Registration Sen-
sor.
Change LCC Control
Board.
Change Control Board.
3 Registration Clutch operation check: the volt-
age across CN7A-4 on LCC Control Board and
GND changes from DC24 V to DC0 V when the
Start key is pressed.
YES Change Registration
Clutch.
NO Change LCC Control
Board.
Change Control Board.
Change Master Board.
To Next Page
Loading...
