Minolta Di251 - Attaching the Paper Feed Unit to the Copy Desk

I-8Di251/Di351 Rev. 1.1.0.0/03.01
left
2. Using the four enclosed fixing plates and fixing plate screws, secure the paper
feed unit to the copy table as shown.
This completes the setup of the copy table.
For instructions on making connections to the copier, refer to “Connecting the Op-
tional Paper Feed Unit to the Copier” in the Setup Instructions for the paper feed
unit.
1.2.6 Attaching the paper feed unit to the copy desk
1. Place the paper feed unit on top of the copy
desk, ensuring that the two are aligned
properly with each other.
2. Using the four enclosed fixing plates and fixing plate screws, secure the paper
feed unit to the copy desk as shown.