FrameMaker Ver.5.5E(PC) Di350 TROUBLESHOOTING
98.12.09
T-28
Code Description Detection Timing
C0650
Faulty Scanner Home Position
Sensor 1 PC12
<The Power Switch is turned ON, Original Cover lowered, or
Start key pressed when the Scanner is at its home position>
•
PC12 is not unblocked (H) even when the Scanner moves
10 mm to the left.
•
PC12 is not blocked (L) even when the Scanner moves 4
mm to the right after PC12 has been unblocked (H).
<The Power Switch is turned ON, Original Cover lowered, or
Start key pressed when the Scanner is at any position other
than home>
•
PC12 is not blocked (L) even when the Scanner moves
469.5 mm to the right.
C0651
Faulty Scanner Home Position
Sensor 2 PC13
When the Start key is pressed with a document loaded in the
Document Feed Tray of AF-7, PC13 is not blocked (L) even
when the Scanner moves 463 mm to the left after PC12 has
been unblocked (H).
C0990
LCC Lift-Up Motor EMOT mal-
function (PF-106)
✽
See option service manual.
C0991
Lift 1 ascent motion failure
(PF-106)
C0995
LCC Transport Motor HMOT
malfunction (PF-106)
C0999
Lift 2 ascent motion failure
(PF-106)
C099D
Communications error (PF-
106)
C0B00
Transport Motor M1 drive mal-
function (FN-100/FN-500)
C0B0F
Paper Entrance Switching
Motor M1 drive malfunction
(FN-100/FN-500)
C0B30
CD Aligning Motor M4 drive
malfunction (FN-100/FN-500)
C0B38
Shift Motor M5 drive malfunc-
tion (FN-100/FN-500)
C0B4D
Paper Holding Tray Motor M10
drive malfunction (FN-100/FN-
500)
C0B4E
Finisher Tray Motor M8 drive
malfunction (FN-100/FN-500)
C0B50
Stapling Motor drive malfunc-
tion (FN-100/FN-500)
C0BA0
Elevator Motor M9 drive mal-
function (FN-100/FN-500)
C0F32
Faulty ATDC Sensor E1 The value of data read by E1 is faulty. [E1 reading is 7% or
less (3.92V or more) or 19% or more (1.41V or less).]
To Next Page
Loading...
