D-82
(4) F5 AIDC Sensor
Make this adjustment after any of the following procedures have been performed:
• Developer replacement
• ATDC replacement
• Memory Clear
NOTE
This adjustment must be made after F8 ATDC Sensor.
Adjustment Procedure
1. Turn the Power Switch ON.
2. Call the Tech. Rep. mode to the screen.
3. Touch [Function].
4. Touch [Printer].
5. Touch [F5 AIDC Sensor].
6. Press the Start Key to let the copier make the F5 AIDC Sensor. (It will run for about 30
seconds.)
NOTE
While the copier is in the adjustment cycle, the Start Key is lit up orange. The key turns
green as soon as the adjustment cycle is completed.
To Next Page
Loading...
