D-20
(4) Removal of the Drawer Lift-Up Motor
1. Remove the Right Door.
2. Slide out the drawer and remove one screw and
the right stopper.
4002D065AB
3. Pushing the tab on the left rail, pull out the drawer.
4002D066AC
4. Remove three screws and the Drawer Set Sensor
Mounting Bracket Assy.
5. Unplug one connector.
NOTE
Reinstall the Drawer Set Sensor Mounting Bracket as
you hold the lever.
4002D067AB
6. Unplug two connectors.
7. Remove one screw and the Drawer Lift-Up Unit.
NOTE
When reinstalling the Drawer Lift-Up Unit, make sure
that the mounting bracket is properly aligned with the
positioning dowel pin on the copier.
4002D262AA
To Next Page
Loading...
