D-25
8. Remove three screws and the Flywheel.
4002D071AB
9. Unplug two connectors and remove five screws
and the Developing Unit Drive Assy.
4002D072AB
10. Unplug two connectors and remove three screws
and the Transport/Synchronizing Rollers Drive
Assy.
4002D073AB
11. Snap off the E-ring and remove the gear.
12. Snap off one E-ring and remove the bushing from
the rear end of the Upper Synchronizing Roller.
4002D074AA
13. Remove three screws and the Cover.
NOTE
Do not remove the belt mounting screw on the cover.
4002D075AB
To Next Page
Loading...
