D-28
(15) Cleaning of the Paper Dust Remover
(16) Disassembly of the Suction Unit
NOTE
When only the Paper Dust Remover is to be replaced,
affix the new one along the reference line as shown on
the left.
4002D517AA
1mm
1. Remove the Synchronizing Paper Dust Remover
Assy.
2. Using a brush, whisk dust off the Synchronizing
Paper Dust Remover.
1136D095AA
1. Remove the Transport Paper Dust Remover Assy.
2. Using a brush, whisk dust off the Transport Paper
Dust Remover.
4002D541AA
1. Remove the Suction Unit.
2. Remove two screws and the duct.
3. Remove four screws and the Suction Drive Unit.
NOTE
When reinstalling the Suction Drive Unit, try to press it
down against the Suction Base Plate.
4002D083AB
4. Remove four driven rolls.
4002D084AB
To Next Page
Loading...
