D-37
2. Wind the fixed bead end of the cable around the
pulley five turns clockwise, from the rear toward the
front side.
4002D003AA
3. Wind the hook end of the cable around the pulley
five turns counterclockwise, from the front toward
the rear side.
NOTE
Make sure that no part of the cable rides on the other.
4002D004AA
4. Slip the Cable Holding Jig onto the pulley to secure
the cable in position.
4002D501AA
5. Position the round bead of the Scanner Drive
Cable in the pulley as shown.
NOTE
Make sure that the bead snugly rests in the slit in the
pulley.
Rear
4002D005AA
Bead
6. Wind the fixed bead end of the cable around the
pulley five turns clockwise, from the front toward
the rear side.
4002D006AA
To Next Page
Loading...
