D-38
7. Wind the hook end of the cable around the pulley
five turns counterclockwise, from the rear toward
the front side.
NOTE
Make sure that no part of the cable rides on the other.
4002D007AA
8. Slip the Cable Holding Jig onto the pulley to secure
the cable in position.
4002D502AA
9. Mount the front and rear pulleys and bushings on
the shaft and install the shaft to the IR Unit.
10. Mount the Scanner Drive Gear on the shaft and
secure it in position with one screw.
4002D115AD
11. Install an Allen wrench into the holes in the shaft
and the IR Base Plate.
4002D116AD
12. Slide the front pulley and bushing to the front and
install one mounting screw.
4002D117AC
To Next Page
Loading...
