D-64
(12) Removal of the Web Roller
(13) Removal of the Web Pressure Roller
1. Remove the Web Roller Assy.
2. Remove two screws and the Web Roller bushing
and Web Take-Up Roller bushing.
NOTE
When reinstalling the Web Roller bushing and Web
Take-Up Roller bushing, ensure that they are in correct
position without being tilted or out of position.
4002D189AA
3. Remove the Web Roller and Web Take-Up Roller.
NOTES
• When reinstalling the Web Roller and Web Take-Up
Roller, wind the web around the Web Take-Up Roller
at least one complete turn. Make also sure that the
web is not slack off.
• When the Web Roller has been removed, clear
Web-Count of Consumables Counter available from
Tech.Rep.mode.
4002D190AB
1. Remove the Web Roller Assy.
2. Remove the Web Roller and Web Take-Up Roller.
3. Remove the springs at the front and rear.
4002D191AB
4. Remove the E-rings and bushings from the front
and rear end and remove the Web Pressure Roller.
4002D192AC
To Next Page
Loading...
