D-80
(2) Orig. Size Adjust
Make this adjustment after any of the following procedures have been performed:
• Memory Clear
• The original size is incorrectly detected
• Replacement of the CCD Unit and Scanner parts
• An Original Size Detecting Sensor has been replaced or added
Adjustment Procedure
2. Call the Tech. Rep. mode to the screen.
3. Touch [I.R. & EDH Check].
4. Touch [Function (I.R.)].
5. Touch [Orig. Size Adjust].
6. Press the Start Key to execute Orig. Size Adjust.
NOTE
The Start key remains lit up orange while this function is being run and lights up green as
soon as the sequence is completed.
7. If the adjustment results have been made okay, touch [Save].
NOTE
If the adjustment results have been NG, refer to “I/O Check List” of TROUBLESHOOTING.
1. Place a blank sheet of A3 or 11 × 17 paper on the
Original Glass and lower the Original Cover.
4002D215AB
To Next Page
Loading...
