4-2
Typical Function Combinations
Chapter 4
1. Making Different Types of Copy
These pages explain how to combine different functions to make various types of copy.
Reading the Table
1. Shows whether the copy is 1-sided or 2-sided.
2. Shows what type of copy you want to make.
3. Shows how to load your original. ☞p. 3-4
4. Shows which to set, either Single-Sided, Double-Sided, 2in1, or 4in1 for Original Copy. ☞p. 3-36
5. Shows which to set, either Corner Staple, 2-Point Staple, or Hole-Punch for the finishing function.
☞p. 3-20
6. Shows the margin position to be set for your original. ☞p. 3-39
7. Shows the file margin function to be set as an auxiliary function. ☞p. 3-54
8. Shows that the stapling position or hole punch positions must be set using the Select Position key.
☞p. 3-24, 3-25
* The marker “-” in the table indicates that no key setting is necessary.
Intended Type of Copy
Loading the
Originals
Copy
Finishing
Functions
Margin
File
Margin
Select
Position
2-Sided
Double-
Sided
Corner
Staple
Double-
Sided
Hole Punch
2-Point
Staple
1
2
3
Turn over
2
3
1
Turn over
2
3
4
5
6 7 8
1
▼
To Next Page
Loading...
