3-3
1. Using Basic Copying Functions
Making Copies
Chapter 3
Useful Tip
Different functions can be combined in various ways to create different types of copy. See “Typical
Function Combinations” that schematically shows different types of copy produced by combining
different functions.
☞
p.4-1
7. Touch [Density].☞ p.3-44
4003P003CA
4003P004CA
Selecting the auxiliary functions
• Changing the exposure level
Selecting the exposure level.
• Making a file margin on the copy
• Using OHP Interleaving
8. Touch [Auxiliary].
☞ p.3-46
123
456
789
0C
9. Setting the number of copies.
From the 10-Key Pad, set the desired number of copies to
be made.
*The maximum number that can be set is 999.
Useful Tip
There is no limit to the number of copies set to be made in
the initial mode. Administrator Mode can, however, be
used to limit the maximum number of copies to be set in the
range from 1 to 99.
☞
p.5-19
* If you have entered an incorrect number, press the clear
key, then enter the correct number.
1139O2640A
10. Pressing the start key
When you press the start key, the machine starts the
copy cycle.
*To stop the copy cycle, press the stop key.
4002O280CB
To Next Page
Loading...
