3-30
5. Selecting the Finishing
Making Copies
Chapter 3
<Z-Fold>
Z-Fold folds the copy into three parts with the
copy surface inside as shown below.
Sizes of paper that can be loaded: 11×17L
* The finished copy size has a length half that of
the paper loaded in the machine.
This feature comes in handy when you combine it
with Staple and Hole Punch for filing.
Number of sheets:
Z-Fold only: 2 to 10
Z-Folded 5 sheets + unfolded 25 sheets
NOTES
• When Z-Fold is selected, Auto Paper is automatically set.
• Z-Fold cannot be used if you make a copy from an original placed directly on the Original Glass.
• Even if control panel settings are made to make 2-sided copies from 1-sided originals, the copies to be
Z-Folded will be 1-sided.
• If control panel settings are made to make 2-sided copies from 2-sided originals, the copies to be Z-
Folded will be 2-sided.
• Whenever Z-Fold is set, the machine runs in the Mixed Original Detection mode.
• Even if Staple is previously set to a center position, the setting of Z-Fold automatically cancels this
setting and reselects a side stapling position.
Touch the desired finishing function key and
then touch [Folding].
Touch [Z-Fold].
Touch [LTR] of Output Size.
To set Staple, touch [Corner Staple] or [2-
Point Staple].
1155O043AA
Orig.
Copy
ex.)11
×
17
→
Letter
1155O642EA
1
4003P039CA
2
4003P045CA
3
4003P346EA
4
4003P347EA
To Next Page
Loading...
