No. Part Name Removal Procedure
1 Front Door Swing down the Front Door. → Remove one screw that
secures the Belt. → Remove two screws that secure the Front
Door (only on one side). → Slide the Door to the side from
which the screws have been removed.
2 Control Panel Swing down the Front Door. → Open the Right Door. →
Remove the Middle Right, Upper Right, and Right Covers. →
Release and swing up the Upper Half of the copier. →
Remove the Upper Left Cover. → Remove two screws that
secure the control panel and loosen another five screws that
secure the control panel.
3 Original Scales
Remove two screws that secure the Scales.
4 Original Glass
5 Rear Upper Cover
(Small)
Remove the Original Cover. → Remove the Left Hinge Cover.
→ Remove the Screw Cover and one mounting screw of the
Rear Upper Cover (Small).
6 Left Hinge Cover Remove the Original Cover. → Remove one screw that
secures the Left Hinge Cover.
7 Rear Upper Cover Remove the Original Cover. → Remove the Right and Left
Hinge Covers. → Remove the Rear Upper Cover (Small). →
Open the Right Door. → Remove the Middle Right, Upper
Right, and Right Covers. → Remove one screw that secures
the Rear Upper Cover.
8 Right Hinge Cover Remove the Original Cover. → Remove one screw that
secures the Right Hinge Cover.
9 Upper Right Cover Open the Right Door. → Remove the Middle Right Cover. →
Remove the Right Cover. → Remove two screws that secure
the Upper Right Cover.
10 Right Cover Open the Right Door. → Remove the Middle Right Cover. →
Remove the Upper Right Cover. → Remove two screws that
secure the Right Cover.
11 Middle Right Cover Open the Right Door. → Remove four screws that secure the
Middle Right Cover.
12 Right Door Open the Right Door and remove it by lifting it up.
13 Manual Bypass Table
Mounting Bracket
Remove two screws that secure the Manual Bypass Table
Mounting Bracket.
14 Counter Cover Remove the Counter Cover by snapping if off.
15 1st Drawer Slide out the 1st Drawer and remove one screw that secures
the Stopper at the rear left corner.
16 2nd Drawer Slide out the 2nd Drawer and remove one screw that secures
the Stopper at the rear left corner.
17 Lower Rear Cover Remove two screws that secure the Lower Rear Cover.
18 Rear Cover Swing down the Front Door. → Release and swing up the
Upper Half of the copier. → Remove two screws that secure
the Rear Cover.
19 Upper Rear Cover Swing down the Front Door. → Release and swing up the
Upper Half of the copier. → Remove three screws that secure
the Upper Rear Cover.
20 Original Cover Remove the Original Cover by pulling it up.
D-6
To Next Page
Loading...
