Minolta EP1080 - Cleaning of the Exposure Lamp; Removal of the Scanner

9. Fit the Cable into the groove in the Wire Guide and
hook the spring.
10. Remove the wrench and Cable Holding Jig.
4. Unplug the Exposure Lamp Terminal connector and
Thermal Fuse Terminal connector.
1. Remove one screw to remove the Exposure Lamp
Terminal.
2. Slide out the Exposure Lamp.
(5) Removal of the Scanner
1. Turn the Scanner Drive Gear to move the Scanner
onto the right-hand side of the copier. Then, remove
four screws to remove the Scanner.
2. Remove one screw to remove the Wire Guide.
3. Remove one screw to remove the Ground Wire.
(6) Cleaning of the Exposure Lamp
D-25