10. Remove four screws to remove the Lower Guide.
11. Snap off two E-rings to remove the Exit/Duplex
Switching Plate.
12. Remove one screw to remove the Photoswitch
Mounting Bracket.
13. Remove two screws to remove the Exit Rolls
Mounting Bracket Unit.
When reinstalling the Exit Rolls Mounting Bracket
Unit, make sure that the Reinforcement Plate Unit is
in contact with the Exit Rolls Mounting Bracket Unit
as shown on the left.
NOTE
14. Snap off two E-rings to remove the Exit Roller.
D-41
To Next Page
Loading...
