Minolta EP1080 - Page 181

1139D032CA
Stop
Start
1
0
3. If the registration does not meet the requirement, go to
the control panel and press the Stop Key, Multi-Copy
Key "0," Stop Key, and Multi-Copy Key "1," in that
order, to set the copier into a state ready to enter a
particular Tech. Rep. Mode.
4. Press the Stop Key and then press the Start Key to
set the copier into the Adjust Mode. (At this time, the
Magnification Ratio Indicator shows "A.")
1139D034CA
AUTO
4
Start
5. Press Multi-Copy Key "4" and press the Start Key.
(Then, the Magnification Ratio Indicator shows "A4"
and the Multi-Copy Display, the current setting value.)
1139D036CA
AUTO
C
6. Press the Clear Key to clear the current setting value.
7. With the old setting value used as reference, enter the
new setting value using the appropriate Multi-Copy
Keys.
1139D019CA
Start
Panel reset
8. Press the Start Key to validate the setting.
9. Press the Panel Reset Key twice (or turn OFF the
Power Switch) to return the copier back to the normal
mode.
10. Make two single copies and check for leading edge
registration on the second copy. (If it does not meet
the requirement, perform steps 3 through 10 again.)
If dimension A on the copy is smaller than 18.5 mm,
decrease the setting value.
If dimension A on the copy is greater than 21.5 mm,
increase the setting value.
NOTE
D-58