(3) Adjustment of the PC Drum Paper Separator Fingers Position
◆Requirement
•
The gap between the PC Drum and the PC Drum Paper Separator Fingers should be 1.0 ±0.5
mm when the Separator Solenoid is in the deenergized position.
◆Important
•
Cover the PC Drum with the Drum Cloth to prevent it from being scratched.
•
Use care not to deform the Separator Fingers during the adjustment procedure.
•
Press part A shown below up against the PC Drum Paper Separator Fingers Positioning Jig for
the adjustment (to prevent the Paper Separator Fingers from being deformed).
1. Install the Sleeve/Magnet Roller Positioning Jig, to
which the PC Drum Paper Separator Fingers
Positioning Jig has been fitted, onto the Imaging Unit.
2. Turn the set screw on each of the two Finger Holders
as necessary for the adjustment.
3. Ensure that part A contacts the PC Drum Paper
Separator Fingers Positioning Jig when the Separator
Solenoid is in the deenergized position.
D-66
To Next Page
Loading...
